Workshop Home

The 6th International FIG Workshop on 3D Cadastres will take place in Delft, the Netherlands, from 2 October (afternoon) until 4 October (morning) 2018. It will be a joint event Geo Delft Conferences 2018 with:

    ISPRS Commission IV ‘Spatial Information sciences’  (1-5 October 2018) Annals and Archives
    3D GeoInfo  (1-2 October 2018) Annals and Archives
    SDSC (Smart Data and Smart Cities)  (4-5 October 2018) Annals and Archives

The increasing complexity of infrastructures and densely built-up areas requires a proper registration of the legal status (private and public), which can only be provided to a limited extent by the existing 2D cadastral registrations. The registration of the legal status in complex 3D situations will be investigated under the header of 3D Cadastres.

The Workshop on 3D Cadastres addresses developments in the following areas:
  • 3D Cadastre operational experiences (analysis, LADM based, learn from each other, discover gaps)
  • 3D Cadastre cost effective workflow for new / updated 3D parcels = 4D (part of whole chain:
    from planning / design / permit in 3D, to registration / use in 3D)
  • 3D Cadastre web-based dissemination (usability, man-machine interfaces, including mobile/AR)
  • Legal aspects for 3D Cadastre, best legal practises in various legislation systems
  • Focus on large cities, including developing countries
The intention is to also include the presentation of overview reports with the progress in the last years in four key areas of 3D Cadastres:
  1. Legal framework 3D Cadastres
  2. Initial registration of 3D parcels
  3. 3D data management
  4. Visualization, distribution and delivery of 3D parcels
Important deadlines for the FIG 3D Cadastre 2018 Workshop are:
22 May 2018   Extended abstract (500-1000 words)
15 June 2018   Reviewing
22 August 2018   Final version full paper
2-4 October 2018   Workshop

Extended abstracts should be submitted via https://easychair.org/conferences/?conf=3dcad2018 (EasyChair) no later than 22 May 2018. Authors of accepted submissions are requested to submit the full paper by 22 August 2018. Full papers will be included in both the on-line and printed proceedings (available at the workshop), published by FIG with ISBN / ISSN reference. Based on the full papers and the presentations at the workshop, a limited number of authors will be invited (after the workshop) to submit a significantly different/ extended paper to a special 3D Cadastres issue within the international scientific journal ‘Land Use Policy’ (LUP).

For workshop paper template and instructions see:
3DCad2018_template.doc   MS Word template for full paper 3D Cadastre Workshop 2018
3DCad2018_instructions.pdf   Instructions for formatting full paper 3D Cadastre Workshop 2018